How To Change Lawn Mower Blades On John Deere

Notice the order that you take off the washers and blade. Installing Mower Blades Install blade D with cutting edge toward the ground.

Pin On Classic John Deere Manuals

Which side of the lawn mower blade is up.

How to change lawn mower blades on john deere. Before you can change a lawn mower blade make sure theres no gas in the mower and disconnect the spark plugs then lift the deck of the mower to expose the blade. Install the wood block on an angle between the old mower blade and the mower deck to keep the blade. Unscrew and remove the cap screws from the blade.

A detailed how to video showing how to remove and replace the cutting blades on a John Deere LA size lawn mower. I also have a video on how i built my. Install the wood block on an angle between the old mower blade and the mower deck to keep the blade from turning when you remove the nut.

Notice how the old blade is oriented so you can put the new ones back in the same orientation. Use a wooden block or a large wrench to keep the blade from spinning. An extension pipe may be need for extra leverage.

Make use of the 58-inch wrench and loosen the bolt in the center in the blade. Dont get that blade upside-down. Next use a wrench to loosen the mounting bolt holding the blade in place to remove it.

Moreover can you put lawn mower blades on upside down. How do you change the blades on a John Deere x300. How to remove the mower deck and replace the blades on a John Deere riding lawn mower with torque specs.

Plus a couple tricks and tips. In this video i show you how to take off your blades Easy without taking the deck offI use my homemade wooden ramps. Most replacement blades are stamped to indicate which side points down.

Once youve determined the need to change the blade the next thing you need to do is park your mower on a flat surface. But if its really worn out then youll need to change it. In order to remove the old blades and install the new blades youll need a wood block and a socket wrench.

With the cutting edge of the new or sharpened blade facing the ground align the center hole with the spindle shaft and place the blade onto the shaft. Place it amongst the mower blade as well as the mower deck. Step 1.

Use a block of wood to prevent the blade from spinning while you tighten the nut. Make sure you switch it off take out the key and put the brake so it wont move while you take out the blade. Install the washer with its cupped side towards the blade and then install the nut.

How to put a blade on and take it off. A 1516-inch socket and a 12-inch drive ratchet are needed to remove the bolt that holds the blade in place. Slide the cutting blade off the blade mount.

This is my first time doing this and it took me only a f. Use the socket to remove the old nut and plate washer. Be cautious to not run your hand into the blade as you loosen the bolt.

In this video I show you how to replace or repair the blades on your John Deere lawn tractormower. One way to ensure that your lawn mower cuts the grass properly is to. Subsequently question is which way do Blades go on John Deere.

Pin On John Deere X300