How To Remove Vinyl Siding From Bottom Up

Circular saw can regulate the depth of cut better. Pull the piece of vinyl siding downward to disengage it from the course below it.

Removing Vinyl Siding Fine Homebuilding

Remove the nails and the piece of siding.

How to remove vinyl siding from bottom up. Measure down from the bottom of siding left in place to the top of the starter strip on both ends and write the distance down on the sheathing so it does not get lost. Then where there are nails slice them off so they are flush with the sheathing. Cut off the lower coarse that you will replace.

Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Use a circular saw or even a multi tool. Repeat until youre at the ground and then remove the surrounding trim.

Then unzip any pieces above the damaged piece. Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip. Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go.

Now you can remove the j. The nails for the first course will be accessible now. If either end of the siding is captured by a door or window channel gently bend the siding to clear the channel as you remove it.

Start by lifting an overlapped piece of vinyl on the top row. To unlock a section of vinyl siding using only a screwdriver find the end joint insert the screwdriver into the bottom locking edge and pry down and out on the edge until you can grab and pull the bottom edge outward and unlock the corner slide the screwdriver. You will actually start by pulling the bottom of the second course out of the top of the first course.

Remove the siding but leave on the starter strip. Once the new sheathings. You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down.

Remove the nails one at a time to disconnect the entire length of vinyl. You will need to remove the bottom course of siding with your removal tool. Ask This Old House general contractor Tom Silva helps a homeowner repair sections of his vinyl siding that have holesSUBSCRIBE to This Old House.

Use a cats paw or other small pry bar to pull the nails from the course you need to remove.

Installing Siding Over Siding How It Can Go Horribly Wrong Case Study