Remove Jumper Cables While Car Is Running

Disconnecting the jumper cables doesnt need to happen in any specific order but be sure you dont let the red and black cables touch each other at the end when they are still connected to one battery. The power surge generated by the jumpstart can short them out.

How To Jump Start Your Car With Jumper Cables And Another Operable Vehicle Roadshow

Then you start the dead car.

Remove jumper cables while car is running. Now no dash lights blinkers all blink fast now front and rear. Once you get your car running. Unplug any accessories like cell phone chargers.

Put your penis in the fan belt. Open the hoods of both cars and locate their batteries. After several minutes you can remove the jumper cables in the following order.

When it starts you should let it run for a while so that it can charge up the dead battery. Turn the key in the dead car to start and it should fire right up. Park the cars close enough for the cables to reach but they should not touch.

Then put the other end of the cables on the dead car. You can disconnect the jumper cables right away. BEFORE taking the jumper cables off of course.

Some batteries may be covered with plastic hoods you need to remove these in order to connect the cables for the jump. When the car has recharged you should remove the jumper cables and be cautious so as to prevent the cables from touching each other. Open both cars hoods and locate the batteries within both of them.

Remove the black clamp from the grounded surface of your vehicle. Begin by parking the vehicle with the good battery next to the car with the dead battery. You could have a faulty alternator.

If they do not match serious damage can occur to both vehicles. Then remove the red positive cable 1st then the black from the now running car and then from the helping car. It is advisable to take the cables from the car that was jump starting the dead battery first.

Remove the red clamp from your batterys positive terminal. Disconnecting the Jumper Cables. Remember to thank the person who helped jumpstart your car.

No power windows no radio no brake lights no rear running lights. Remove the other black clamp from the negative terminal of the good battery. Disconnect the cables in the reverse order.

If the batteries are covered by plastic hoods remove the hoods so the battery posts are exposed. Red 1st then black. If the vehicle starts remove the cables in the reverse order they were put on being careful not to let them touch.

First remove the negative cable from the car you jumped then the negative cable from the car with the good battery. You have the good car running and attach the jumpers to it. Once your dead car has started and is running immediately disconnect the jumper cables in the reverse order.

Your car is running but your job isnt over. Turn the engine off in the car with the good battery. No jump box cables or charger around so took battery from late 70s early 80s ford pickup hooked up to mine started no problem then removed truck battery and connected mine while running.

With jumper cables still hooked to your car start your engine then remove the jumper cables. The car with the good battery needs to be parked closely to the car with the dead battery. The batteries have both positive and negative - posts.

Then remove the positive cable from the car with the good battery dont touch a grounded part of either car with the clamp of the positive cable. Connect the Cables. Carefully install your new battery and tighten the terminals.

Red 1st then black. Once you remove the jumpers if a car shuts down immediately its the alternator not the battery battery is primarily for starting the car not keeping it running.

I Accidentally Crossed The Jumper Cables This Is What Happened